Installation Of The Attic Board - Avaya Octel 200 Installation And Maintenance Manual

Message servers
Hide thumbs Also See for Octel 200:
Table of Contents

Advertisement

7.1-38
Integration Volume
Internal Call Forwarded on Forward All Calls
m. Set phone B to forward all calls to the Octel 200/300 hunt group.
n. Using phone A, call phone B. Press the Inspect Mode key to look at the displays of the ringing
line on the digital phone. The second line of the display should contain this information:
a = Test A EXT−A to Test B EXT−B
If the display does not contain this information, determine the cause and correct the problem
before continuing.
o. Hang up phone A, and cancel the Send All Calls feature on phone B.
a = Test1 EXT−T1
12. CALLS TO THE INTERCEPT EXTENSION (ATTENDANT) (New installation only)
This test verifies that each Octel 200/300 port extension can transfer a call to the intercept
extension (attendant).
a.
Connect the analog adapter to the 25-pin cable associated with slot 1.
b. Connect phone B to the jack position of the modular adapter that is associated with port 1 of the
Octel 200/300.
c.
From phone A, call the extension number of phone B.
d. Answer phone B, perform a hookswitch flash, and press
number). Hang up phone B.
e.
Does phone A get connected to the attendant?
NO '
f.
Connect phone B to the jack position of the modular adapter of the next Octel 200/300 port
extension. Repeat steps b. through d. until every Octel 200/300 port has successfully transferred
a call to the attendant.
The DEFINITY G3i testing is now complete. Proceed with installation of the ATTIC board.

Installation of the ATTIC Board

This section describes the procedure for installing the ATTIC board. Before proceeding with installation,
note that there are six LEDs on the front edge near the top of the ATTIC. These are used to indicate card
status and are, from top to bottom:
Integration Unit 1 Link 1
Integration Unit 1 Link 2
Integration Unit 2 Link 1
Integration Unit 2 Link 2
Octel 200/300
S.4.1
Determine the cause and correct the problem before continuing.
LED Name
Down
Good
(or the attendant's extension
0
LED Color
Red
Green
Yellow
Yellow
Yellow
Yellow
r
PB60019-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Octel 300

Table of Contents