Replace The Hydraulic Tank Breather Cap - Models With Optional Hydraulic Oil - Genie GR-20J Service Manual
Serial number range from grj10-101 to grj16-1151, from grj16l-1152 to grj16l-1999, from grjl-2000
Hide thumbs
Also See for GR-20J:
- Operator's manual (48 pages) ,
- Installation instructions manual (11 pages)
Table of Contents
Advertisement
September 2016
C-2
Replace the Hydraulic Tank
Breather Cap - Models with
Optional Hydraulic Oil
Genie specifications require that this procedure be
performed every 500 hours or six months,
whichever comes first OR when the machine fails
to lift the maximum rated load.
The hydraulic tank is a vented-type tank. The
breather cap has an internal air filter that can
become clogged or, over time, can deteriorate. If
the breather cap is faulty or improperly installed,
impurities can enter the hydraulic system which
may cause component damage. Extremely dirty
conditions may require that the cap be inspected
more often.
1 Remove breather cap from the hydraulic tank.
Discard the breather cap.
Note: The tank filler cap and breather are one
piece component.
2 Install a new breather cap onto the hydraulic
tank.
Part No. 227656
Section 3 • Scheduled Maintenance Procedures
GR-20J • GR-26J
CHECKLIST C PROCEDURES
3 - 25
Hide quick links:
Advertisement
Table of Contents
