Configuring Communication To The Control; Select Telegram - Siemens SINAMICS G120 Operating Instructions Manual

Configuring the fieldbus
8.1 Communication via PROFINET
8.1.3

Configuring communication to the control

In order to establish communication between the converter and control system via
PROFINET, you must load the device file of the converter "GSDML" into your control. You
can then configure the communication.
Procedure
● Import the GSDML of the converter into thePROFINET-Controller, i.e. into your control
● Configure the communication between the control and the converter in your control.
8.1.4

Select telegram

During basic commissioning, you have defined a telegram for communication. In order to set
a different telegram, you may need also adapt the assignment of the interfaces.
Procedure
Carry out the basic commissioning again
● Adapt the interface assignment
● Select the telegram.
Table 8- 2
Parameter
p0015
p0922
88
system.
You can obtain the GSDML of your converter in two ways:
– You can find the GSDML of the SINAMICS converter on the Internet
(http://support.automation.siemens.com/WW/view/en/22339653/133100).
– The GSDML is saved in the converter. If you insert the memory card in the converter
and set p0804 = 12 , the GSDML will be written to the
/SIEMENS/SINAMICS/DATA/CFG folder on the memory card.
Parameters for setting the telegram
Description
Macro drive unit
Configure the interface in basic commissioning, and select a telegram. See also the
section: Selecting the interface assignments (Page 44).
PROFIdrive Telegram selection (factory setting for converters with PROFIBUS- or
PROFINETinterface: Standard telegram 1, PZD-2/2)
Set the send and receive telegram, see Cyclic communication (Page 93)
1: Standard telegram 1, PZD-2/2
20: Standard telegram 20, PZD-2/6
352 SIEMENS telegram 352, PZD-6/6
353: SIEMENS telegram 353, PZD-2/2, PKW-4/4
354: SIEMENS telegram 354, PZD-6/6, PKW-4/4
999: See Extend telegrams and change signal interconnection (Page 98).
SINAMICS G120C frequency converter
Operating Instructions, 03/2012, FW V4.5, A5E02999804B AB