Table of Contents
Advertisement
4.6 INSTALL THE WASTE BOTTLE
Step 1 :
Hook the waste bottle assembly over the four pre-mounted screws and push it downwards.
Step 2 :
Tighten the four screws.
Step 3 :
Loosen the 2 waste tubes attached to the printer with some tape.
Step 4 :
Install the tubes at the top of the waste bottle.
Be sure that the tubes are installed strongly over the nipples to be sure that no waste liquid can
leak out during printing.
CS9200 Low Solvent series printers
32
AP-40301 – Rev. 2.0 – 02/05/2008
Advertisement
Table of Contents
