Copy The Contents Of Lic Log - IBM i 830 Repair Manual

Dedicated Service Tools (DST). Do not select F10 from the Disk
Configuration Attention Report display when you are performing
this Recover Remote Load source procedure.
Note: At this time, the load source disk is the only configured disk
unit in the system. The following steps ensure that the
destruction of customer data and programs will not occur.
Continue with the next step of this procedure.
5. Select the Start the Dedicated Service Tools option.
6. Sign on to DST.
Use 22222222 as both the used ID and password. If the customer has changed
the ID or password, ask the customer for the correct values.
7. Select the Work with disk units option.
8. Select the Work with disk unit recovery option.
9. Select the Recover Mirrored Load source option.
This function, checks the disk units that are attached to the system. If remote
mirroring became enabled and a mirror protected, load source disk unit is
located, a confirmation display appears. If a mirror protected, load source disk
unit is not located, an error display appears.
10. After the confirmation display appears, press F10 to confirm the selection and
begin the recover function.
While the Recover Remote Load source function is running, SRC C6xx 4205
(xx represents the percentage of recovery completed) displays on the system
control panel.
When the Recover Remote Load source function completes. The system
automatically performs an IPL from disk to the IPL or Install the System
display. All of the system data, user data, and user ASPs are now available to
the system.
This ends the procedure.

Copy the Contents of LIC Log

Attention: The file does not close until you select the End Licensed Internal Code
option. If you remove the tape or diskette before selecting this option, do not use
the information that is on the tape or diskette.
1. Select the Start a Service Tool option on the Use Dedicated Service Tools (DST)
display.
2. Select the Licensed Internal Code log option.
3. Select either:
v Dump entries to tape from the LIC log
v Dump entries to diskette from the LIC log
4. Perform the following:
a. At the bottom of the Dump entries to tape (or diskette) from LIC log
display, type a 3 (Dump entry header and complete entry).
b. Press the Enter key.
5. The system will prompt you through the remainder of the displays that are
used in this procedure.
When the copy of the LIC log contents finishes, a message appears indicating
that the dump (copy) completed.
a. Press the Enter key.
Chapter 6. Data Recovery Procedures and General System Information
Data Recovery and General System Information
919