IBM i 830 Repair Manual page 371

4. Select the Analyze log option on the Product Activity Log display.
5. On the Select Subsystem Data display, select the option to view All Logs.
Note: You can change the From: and To: Dates and Times from the 24 hour
default if the time that the customer reported having the problem was
more than 24 hours ago.
6. Use the defaults on the Select Analysis Report Options display by pressing the
Enter key.
7. Search the entries on the Log Analysis Report display for system reference
codes associated with the missing disk units.
8. Go to "Chapter 2. Unit Reference Codes" on page 59 and use the SRC
information to correct the problem.
This ends the procedure.
000B: Some system IOPs require cache storage be reclaimed.
Select DST using Function 21 (see "Control Panel Functions" in the iSeries Service
Functions information).
Reclaim the cache adapter card storage (see "Reclaim IOP Cache Storage" on
page 947).
Note: The system operator may want to restore data from the most recent saved
tape after you complete the repair.
This ends the procedure.
000C: One of the mirror protected disk units has no more alternate sectors to
assign.
1. Determine the failing unit by type, model, serial number or address given in
words 4-7 (see "Hardware SRC Formats" in the iSeries Service Functions ).
2. See the service information for the specific storage device. Use the disk unit
reference code listed below for service information entry.
432x 102E, 660x 102E, 671x 102E (see Chapter 2. Unit Reference Codes)
9337 7xx0, 8xx0, Dxx0, Exx0 (x can be a number from 0 through 8)
This ends the procedure.
000D: The system disk capacity has been exceeded.
For more information about disk capacity, see iSeries 400 Handbook, GA19-5486-20 .
This ends the procedure.
000E: Start compression failure.
Select Manual mode and perform an IPL to DST (see "Dedicated Service Tools
(DST)" in the iSeries Service Functions information).
Correct the problem by doing the following:
1. Select the Work with disk units option.
2. Select the Work with disk unit recovery option.
3. Select the Recover from start compression failure option.
Chapter 3. Problem Isolation Procedures (PIPs), Failing Items, and Symbolic FRU Isolation
LIC PIPs
357