Storioa; Svcdocs; Svcproc; Sysbkpl - IBM i 830 Repair Manual

Symbolic FRUs

STORIOA

Replace the storage I/O Adapter. Use the I/O Adapter location information in the
Service Action Log if it is available. If the location is not available, find the address
of the I/O Adapter. See "SRC Address Formats" on page 936. Use the address to
find the location. See "Locations and Addresses" on page 705.
If the failing item is in a migration tower, go to the STORIOA symbolic FRU in the
Migrated Expansion Tower Problem Analysis, Repair and Parts.
This ends the procedure.

SVCDOCS

See the Description/Action column in the "Chapter 2. Unit Reference Codes" on
page 59 for the Unit Reference Code you have.
This ends the procedure.

SVCPROC

The service processor is failing.
If the system is failing during IPL and you recently loaded and applied PTFs, or
the failure first occurred during a mode D IPL, or the previous IPL ended in an
unexpected power off, then attempt to reload service processor code.
Use the system model and the table below to determine the service information for
the failing component.
This ends the procedure.

SYSBKPL

The failing component is built into the backplane of the system unit. Use the
system model and the table below to determine the service information for the
failing component.
598
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1
Table 37.
System Model Name of FRU
to Exchange
Models 830 Tower Card
and SB2 base
I/O tower (FC
9074)
Models 840 Tower Card
and SB3 base
I/O tower (FC
9079)
FRU Position Link to Locations
Diagram
CB1 "Locations —
Models 830, SB2
System Unit with
FC 9074 Base I/O
Tower" on
page 709.
CB1 Figure 36 on
page 724.
Link to Failing
Component Service
Information. (CCIN,
PN, Removal and
Installation
Procedure)
Table 41 on
page 710.
Table 43 on
page 725.