IBM i 830 Repair Manual page 372

LIC PIPs
4. Follow the on-line instructions.
This ends the procedure.
0010: The disk configuration has changed.
The operating system must be installed again and all customer data must be
restored.
Select Manual mode on the control panel (see iSeries Service Functions). Perform an
IPL to reinstall the operating system.
Note: The customer must restore all data from the latest system backup.
This ends the procedure.
0011: The serial number of the control panel does not match the system serial
number.
Select Manual mode on the control panel (see iSeries Service Functions). Perform an
IPL. You will be prompted for the system serial number.
This ends the procedure.
0012: The operation to write the vital product data (VPD) to the control panel
failed.
Exchange the multiple function I/O processor card (see "Chapter 4. Removal and
Installation Procedures" on page 617). For the location of the card, see "Locations
and Addresses" on page 705.
This ends the procedure.
0015: The mirrored load-source disk unit is missing from the disk configuration.
Go to step 1 for cause code 0002.
0016: A mirrored protected disk unit is missing.
Wait 6 minutes. If the same reference code appears, go to step 1 for cause code
0002.
0017: One or more disk units have a lower level of mirrored protection than
originally configured.
Select Manual mode and perform an IPL to DST (see "Dedicated Service Tools
(DST)" in the iSeries Service Functions information).
The detailed display shows the new and the previous levels of mirrored protection.
This ends the procedure.
0018: Load-source configuration problem.
The load-source disk unit is using mirrored protection and is configured at an
incorrect address.
358
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1