IBM i 830 Repair Manual page 124

Table of Contents

Advertisement

1xxx
Reference Code
Description/Action Perform all actions before exchanging Failing Items
90F0
A frame was dropped from the SPCN configuration.
A frame was dropped from the SPCN configuration. This is usually caused
by a loss of ac power or a problem with the frame-to-frame cable.
90F1
A frame was added to the SPCN configuration.
No action required. This reference code is logged for information only.
9100
Battery capacity test completed.
No action required. This reference code is logged for information only.
9101
VLIC-SPCN Timeout
A Licensed Internal Code timeout occurred. The SPCN failed to respond to
a Licensed Internal Code command.
9102
Assign Permanent Address command failure
A node failed to perform an Assign Permanent Address command.
9103
Download Initialize Timeout
An SPCN node failed to enter the download state after an Initialize for
Download command.
Exchange the failing SPCN node.
9104
Download Completion Timeout
An SPCN node failed to leave the download state.
Exchange the failing SPCN node.
9105
Load Damaged Timeout
An SPCN node failed to enter the operational state.
Exchange the failing SPCN node.
9106
An SPCN LID was not found.
No action required. This reference code is logged for information only.
9107
An SPCN microcode download is required.
No action required. This reference code is logged for error analysis only.
9108
A status change occured in one of the SPCN nodes.
No action required. This reference code is logged for information only.
9109
Licensed Internal Code part number is not correct.
The AROS part number field was not updated to the correct level after the
system attempted to load new Licensed Internal Code.
9110
Battery Power Unit capacity test failed.
The battery power unit was not able to pass the capacity test.
9111
SPCN is too large for VLIC.
There are more nodes in the network than VLIC can service.
9112
Primary SPCN node is reporting load damaged.
The Licensed Internal Code for the primary SPCN node is damaged. The
reload failed because the code could not be found.
110
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1
Failing Item
TWRCARD
CBLALL
TWRCARD
CTLPNL
SVCPROC
TWRCARD
TWRCARD
TWRCARD
TWRCARD
TWRCARD
BATRY
AJDG301
TWRCARD

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

I sb3I 840I sb2

Table of Contents