IBM i 830 Repair Manual page 929

d. Select the Work with disk unit recovery option on the Work with Disk
Unit display.
e. Select the Recover configuration option on the Work with Disk Unit
Recovery display. This option assembles the system configuration
information on disk unit 1 in the system unit.
Notes:
a. A warning message appears stating that recovering the configuration
destroys all system data.
b. If you have a system with only one disk unit, a message may appear
stating that your request to recover the configuration was not successful.
The recover configuration function cannot be performed on a system with
only one disk unit.
Continue with the next step of this procedure.
18. The ASP to which the failing disk unit was assigned is cleared. The customer
should do the following:
v If the disk unit you exchanged is in ASP 1, have the customer see the
Backup and Recovery information. You must restore the operating system
(OS/400 Licensed Program) and all customer data.
v If the disk unit is in a user ASP (ASP 2 through ASP 16), data in the ASP is
lost. See the Backup and Recovery information.
This ends the procedure.
19. Perform an IPL from removable media and restore the Licensed Internal Code
(see "Restoring Licensed Internal Code" in the iSeries Service Functions
information). This information shows you how to perform an IPL and restore
the Licensed Internal Code.
Note: Some objects may be damaged. The customer may have to load the
damaged objects again (see the Backup and Recovery information).
This ends the procedure.
20. Is the failing unit missing from the configuration?
No Yes
↓
Go to step 31 of this procedure.
21. Find another disk unit on the system, other than the load-source disk unit.
22. Perform the following to install a new disk unit on the system:
a. Power off the system.
b. Slide the disk unit you found in step 21 of this procedure out of the
system (see "Chapter 4. Removal and Installation Procedures" on
page 617).
c. Be very careful with the disk unit. You will install it again when the repair
actions to the failing disk unit are complete.
d. Install the new disk unit.
23. Perform an IPL to DST (see "Dedicated Service Tools (DST)" in the iSeries
Service Functions information).
Does the Use Dedicated Service Tools (DST) display appear?
Yes No
↓
Repeat step 1 of this procedure.
Chapter 6. Data Recovery Procedures and General System Information
Data Recovery and General System Information
915