IBM i 830 Repair Manual page 388

LIC PIPs
33. Intermittent equipment checks may have caused this problem.
34. Fill out a Problem Summary Form using the information from words 1
35. Are words 3 - 9 on the Problem Summary Form the same as on the Problem
36. Are characters 13-16 of the bottom 16 character line of function 13 (4
37. Go to the analyzing problems procedures in the service information for the
38. A manual reset of the IOP may clear the attention SRC. Perform the steps in
374
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1
Yes No
↓
Go to step 34 of this procedure.
Display the system product activity log and look for entries that contain unit
reference codes or IOP reference codes that may need action.
You can read a unit reference code history from the disk controller service
panel.
This ends the procedure.
through 9 from the control panel.
Are characters 5-8 of the top 16 character line of function 11 (4 rightmost
characters of word 1) on the Problem Summary Form the same as on the
Problem Summary Form filled out in step 2 of this procedure?
Yes No
↓
A different SRC or reference code occurred. Use the new SRC or
reference code to correct the problem (see "Chapter 2. Unit Reference
Codes" on page 59).
This ends the procedure.
Summary Form filled out in step 2 of this procedure?
Yes No
↓
A different SRC or reference code occurred. Use the new SRC or
reference code to correct the problem (see "Chapter 2. Unit Reference
Codes" on page 59). This ends the procedure.
This ends the procedure.
rightmost characters of word 9) on the Problem Summary Form you filled out
in 34 of this procedure equal to 0000?
Yes No
↓
Return to "Chapter 2. Unit Reference Codes" on page 59. Analyze the
problem using the data in characters 9-16 of the bottom 16 character
line of function 13 (word 9) on the Problem Summary form in place of
the data in word 1, which originally sent you to this procedure.
This ends the procedure.
specific disk unit to analyze the status of the failing unit. Then return here
and answer the following question.
Did the service information for the specific disk unit correct the problem?
No Yes
↓
This ends the procedure.
the following table: