IBM i 830 Repair Manual page 365

↓
Go to step 1 for cause code 0002.
3. Select option 5 on the Missing Disk Configuration display.
Select the Display Detailed Report option and follow the instructions to:
a. Select the Work with disk units option.
b. Select the Work with disk unit recovery option.
c. Select the Recover Configuration option and follow the instructions on the
display.
Note: After the disk configuration is recovered, the system automatically
performs an IPL.
This ends the procedure.
0002: Disk units are missing from the disk configuration.
Data from the control panel can be used to find information about the missing disk
unit. See "Hardware SRC Formats" in the iSeries Service Functions.
1. Did you enter this procedure because all the devices listed on the Display
Missing Units display (reached from the Disk Configuration Error Report or
the Disk Configuration Warning Report display) have a reference code of
0000?
No Yes
↓
Go to step 22 of this procedure.
2. Have you installed a new disk enclosure in a disk unit and not restored the
data to the disk unit?
No Yes
↓
Ignore SRC A600 5090.
Continue with the disk unit exchange recovery procedure (see "Disk
Service Support" in "Recovery Procedures" on page 893).
This ends the procedure.
3. Use words 1-9 from the information recorded on the Problem Summary Form
to determine the disk unit that is missing from the configuration:
v Characters 1-8 of the bottom 16 character line of function 12 (word 4)
contain the IOP direct select address.
v Characters 1-8 of the top 16 character line of function 13 (word 6) contains
the disk unit type, level and model number.
v Characters 9-16 of the top 16 character line of function 13 (word 7) contains
the disk unit serial number.
Note: For 2105 and 9337 Disk Units, the 5 rightmost characters of word 7
contain the disk unit serial number.
v Characters 1-8 of the bottom 16 character line of function 13 (word 8)
contains the number of missing disk units.
Are the problem disk units 432x, 660x or 671x Disk Units?
No Yes
↓
Go to step 5 of this procedure.
4. Attempt to get all devices attached to the MSIOP to Ready status by
performing the following:
Chapter 3. Problem Isolation Procedures (PIPs), Failing Items, and Symbolic FRU Isolation
LIC PIPs
351