Proc2; Proc3 - IBM i 830 Repair Manual

Symbolic FRUs
4. This is a Model 840, SB3 System Unit and FC 9079 Base I/O Tower.
This ends the procedure.

PROC2

The failing item a system processor card.
1. Attempt a SLOW OVERRIDE IPL to run full processor hardware diagnostics.
2. Is this system a Model 830 with SB2 System Unit and FC 9074 ?
3. See "Locations — Models 830, SB2 System Unit with FC 9074 Base I/O Tower"
4. This is a Model 840, SB3 System Unit and FC 9079 Base I/O Tower.
This ends the procedure.

PROC3

The failing item a system processor card.
1. Attempt a SLOW OVERRIDE IPL to run full processor hardware diagnostics.
570
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1
Note: Be sure to IPL in SLOW OVERRIDE mode after each replacement.
a. Processor Card in location M04 in the System Unit
See "Locations — Models 840, SB3 System Unit with Processor Tower and FC
9079 Base I/O Tower" on page 719. Replace the following FRUs in order one at
a time until the problem is resolved. See "Chapter 4. Removal and Installation
Procedures" on page 617.
Note: Be sure to IPL in SLOW OVERRIDE mode after each replacement.
a. Processor Card 1 in location M18 in the System Unit
Power off the system from the control panel. Change the IPL mode to manual,
and the IPL speed to SLOW OVERRIDE (S) using control panel function 2.
Power on the system.
Does the same SRC occur ?
Yes No
↓
Follow the service actions for the new SRC.
Yes No
↓
Go to Step 4 of this procedure.
on page 709.
Replace the following FRUs in order one at a time until the problem is
resolved. See "Chapter 4. Removal and Installation Procedures" on page 617.
Note: Be sure to IPL in SLOW OVERRIDE mode after each replacement.
a. Processor Card in location M03 in the System Unit
See "Locations — Models 840, SB3 System Unit with Processor Tower and FC
9079 Base I/O Tower" on page 719. Replace the following FRUs in order one at
a time until the problem is resolved. See "Chapter 4. Removal and Installation
Procedures" on page 617.
Note: Be sure to IPL in SLOW OVERRIDE mode after each replacement.
a. Processor Card 2 in location M06 in the System Unit
Power off the system from the control panel. Change the IPL mode to manual,
and the IPL speed to SLOW OVERRIDE (S) using control panel function 2.
Power on the system.