IBM i 830 Repair Manual page 550

Symbolic FRUs
2. Find the IOA type, the attached device, the cable length, and the cable part
3.
IOP or IOA Type
2749
2768
This ends the procedure.
536
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1
b. Use the location information of the IOA in the Service Action Log if it is
available. If the location is not available, find the address. See "SRC Address
Formats" on page 936. Use the address to find the location. See "Locations
and Addresses" on page 705.
c. Find the IOA card in the system and read the type number of the card at
that location.
number in the following list.
Note: Verify that the part number in the list is the same as the part number on
the cable.
For external devices that are not found in the following list, use the device
type and refer to the appropriate service documentation for that device. The
service documentation for that device will help you determine the FRU part
numbers and replacement procedures you are to use during this repair action.
If you are unable to locate the documentation for your specific device, then
contact your next level of support for assistance.
Device
3490, 3490/Exx, 3590
3490/Fxx, 3570, 358x, 9427,
7208/342
63A0
7208/012, 7208/222
7208/232, 7208/234, 9348
3995
7207/122, 7208/345,
7210/020, 7329/308
Note: All cables for the 9427 tape library must include an interposer, part
05H3834, on the device end of the cable.
Lengths
2.8 meters
4.5 meters
12.0 meters
18.0 meters
25.0 meters
0.5 meters
4.5 meters
12.0 meters
18.0 meters
1.5 meters
4.0 meters
12.0 meters
0.5 meters
4.0 meters
12.0 meters
12.0 meters
2.4 meters
Part Number
05H4647
05H4648
05H4649
05H4650
05H4651
49G6456
49G6457
49G6458
49G6459
See device documentation
to determine cable Part
Number(s)
52G0174
59H3462
59H3463
06H6037
59H3460
59H3461
59H3461
67G1260