IBM i 830 Repair Manual page 195

Reference Description/Action Perform all actions before exchanging
Code Failing Items
4691 to 4697 Service processor Licensed Internal Code
Perform INT-PIP24.
4698 Operator/User Error
4699 Service processor Licensed Internal Code
Perform INT-PIP24.
469A Service processor Licensed Internal Code
Perform INT-PIP24.
469B Service processor LIC problem
Record all the SRC data words, attempt a main storage dump,
and replace the FRUs listed if necessary.
469C Service processor Licensed Internal Code
Perform INT-PIP24, then replace the FRUs listed if necessary.
469D Service processor Licensed Internal Code
If this SRC is displayed at the system console dump manager
screen then save the main storage dump and report the LIC
failure to service. If this SRC is displayed at the control panel
then perform INT-PIP24.
469E Service processor Licensed Internal Code
Perform INT-PIP24.
469F Service processor Licensed Internal Code
Perform INT-PIP24.
4998 Operator/User Error
6010 Any device attached to Bus 1
8FF0 Information only, no service action required
Service processor error log entry.
If the secondary refcode is 806A, a successful
download of control panel code has occured.
If the secondary refcode is 8EEE, one of the following
conditions may have occured.
Operation was successful but current
keylock position was not in Auto or normal.
The Time-of-Day (TOD) chip had to be reset
due to an invalid power-up state. TOD
requests will not work successfully until
a write TOD is done (CHGSYSVAL QDATE).
Timed-Power-On request has been acknowledged.
Power on sequences must be set for valid months,
days, hours, minutes, and seconds, for future
times, and for times when the system will be
powered off.
A1xx, B1xx
Failing Item Location
AJDGP01
OPUSR
AJDGP01
AJDGP01
AJDG301
AJDG301
BUS1
AJDGP01
BUS1
AJDGP01
AJDGP01
SYSUNIT
SVCPROC
AJDGP01
SVCPROC
SYSUNIT
UCSUSER
BUS1
Chapter 2. Unit Reference Codes
181