Fc 5074, Fc 5079, Fc 9079 (With Single Line Cord) - Ac Charger - A01; Fc 5074, Fc 5079, Fc 9079 (With Dual Line Cord) - Ac Charger - A01 - IBM i 830 Repair Manual

Remove and Replace Procedures
Models 840/SB3 – Time of Day (TOD) Battery .
Disk Unit – Dedicated and Concurrent .
Disk Unit, Models 830/SB2 and 840/SB3 –
Dedicated and Concurrent .
Concurrent Maintenance – Removal and
Installation . . .
Dedicated Maintenance – Removal and
Installation . . .
Attention: If removing the cover while powered on, errors may occur due to
Electromagnetic Interference.
This is the starting point for all remove procedures in the 1.6 meter rack. Perform
the following steps.
Attention: It is not always necessary to power off the system to exchange a field
replaceable unit (FRU). You will be directed through a concurrent exchange, if
possible, for disk or removable media storage units.
1. Find the location of the part you are replacing in "Locations and Addresses" on
2. If you are removing a IOA, IOP, IXS card, disk unit or removable media unit,
3. Find the FRU you are removing in this section and follow the procedures.
4. When you have completed the remove procedure, install the FRU by reversing
5. After exchanging an item, see "Verifying the Repair" on page 920.
FC 5074, FC 5079, FC 9079 (With Single Line Cord) – AC Charger – A01
1. Power off the expansion tower. (See "Powering On and Powering Off the
2. Disconnect the incoming AC power cord from the expansion tower.
3. Open the rear cover. (See "FC 5074, FC 5079, FC 9079 – Covers" on page 623.)
4. Disconnect all the power cords from the battery charger.
5. Remove the screws that are holding the charger to the frame.
6. Remove the battery charging unit.
7. Install the battery charger by reversing the removal procedure. After
This ends the procedure.
FC 5074, FC 5079, FC 9079 (With Dual Line Cord) – AC Charger – A01
1. Do Not Power Down the tower if it is powered on. (This can be done
2. Open the rear cover. See "FC 5074, FC 5079, FC 9079 – Covers" on page 623.
3. See the Table 44 on page 737.
4. Trace the AC input line cord that connects to AC module that needs replacing
618
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1
. 697
. . . . 698
. . . . . . . 698
. . . . . . . . . 698
. . . . . . . . . 700
page 705.
you may be able to use the concurrent procedures and keep the system up and
running.
the remove procedure unless otherwise noted.
System and Logical Partitions" on page 922.)
exchanging an item, go to "Verifying the Repair" on page 920.
concurrently.)
and disconnect that AC line cord.
Attention: Do not disconnect the other system AC line cord when powered
on.
Tape Cartridge – Manual Removal .
6383, 6385, 6386, 6387 Tape Cartridge .
Locked Position .
Standby Position .
1/4 inch Tape Cartridge (Type 6335).
Optical Media – Manual Removal
CD-ROM and DVD .
Emergency Disc Ejection Function
. . . . . 701
. . . 701
. . . . . . . . . 701
. . . . . . . . . 701
. . . . 702
. . . . . . 704
. . . . . . . . . 704
. . . . 704