IBM i 830 Repair Manual page 106

1xxx
Reference Code Description/Action Perform all actions before exchanging Failing Items
2410 to 2411 UPS Test Failure
2413 UPS Interface Failure
2600 Power Good Fault
2601 to 2604 Power Good Fault
2610 Processor/Memory Card not installed
2612 Optical Converter 5V Fault
The SPCN detected a fault on the SPCN card optical converter 5V.
2613 Configuration Requires 200V Input
Configuration now requires 200V AC power.
300E EPO Circuit Fault
The ac module installed in the 9406 Expansion Unit (FC 504x) detected a
fault in the UEPO signal. The signal was active and the incoming ac
voltage was still present.
302B PCC Overcurrent
The power control compartment is causing an over current condition in the
9406 Expansion Unit power system.
Exchange the ac module and the SPCN port cable at the same time.
3100 I2C Bus Controller Communication fault
3101 I2C Bus 1 Communication fault
3102 I2C Bus 2 Communication fault
3103 I2C Bus 3 Communication fault
3104 I2C Bus 4 Communication fault
3105 I2C Bus 5 Communication fault
3106 I2C Bus 6 Communication fault
3110 I2C Bus DASD Backplane 1 Communication fault
3111 I2C Bus DASD Backplane 2 Communication fault
3112 I2C Bus DASD Backplane 3 Communication fault
3113 I2C Bus Adapter Communication fault
92
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1
Failing Item
UPSUNIT
SPNLCRD
UPSUNIT
SPNLCRD
PGDPART
TWRCARD
PWRSPLY
PGDPART
TWRCARD
PWRSPLY
TWRCARD
CBLALL
TWRCARD
CBLALL
TWRCARD
21F9362
21F5680
TWRCARD
21F5680
21F9631
21F9362
I2CBUS
TWRCARD
I2CBUS
TWRCARD
I2CBUS
TWRCARD
I2CBUS
TWRCARD
I2CBUS
TWRCARD
I2CBUS
TWRCARD
I2CBUS
TWRCARD
I2CBUS
TWRCARD
I2CBUS
TWRCARD
I2CBUS
TWRCARD
I2CBUS
TWRCARD