Power Pip8 - IBM i 830 Repair Manual

Power PIPs
10. Perform the following:
11. Have you reconnected all the cards?
12. Replace processor backplane location MB1 symbolic FRU SYSBKPL.

Power PIP8

A power supply is reporting a load fault in a FC 5078/0578. Read the "Overview"
Note: Determine if the system has logical partitions. Go to "Determining if the
1.
394
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1
Yes No
↓
The AMD that you removed in this step is the failing item.
This ends the procedure.
7. Have you removed all of the AMDs one at a time?
No Yes
↓
Install all the AMDs and continue with step 9 of this procedure.
8. Perform the following:
a. Power off the system.
Install the AMD that was removed in step 6 on page 393 in the original
b.
location.
c. Go to step 6b on page 393.
9. Replace processor backplane location MB1 symbolic FRU SYSBKPL.
This ends the procedure.
a. Reinstall 1 of the cards that you removed in step 1 of this procedure in the
following order:
v M01
v M06
v M02
v M05
v M03
v M04
b. Reconnect the AC power cable to the unit that you are working on.
c. Power on the system.
Does a power reference code occur?
No Yes
↓
Exchange the last card that you reinstalled in this step.
Yes No
↓
Repeat step 10 of this procedure reinstalling next card.
This ends the procedure.
on page 387, before continuing with this procedure.
System Has Logical Partitions" on page 943, before continuing with this
procedure. If the system has logical partitions, perform this procedure only
from the Primary partition's console and the system control panel.
Perform the following (for location information, see "Locations — FC 5078,
0578 PCI Expansion Unit" on page 743):