IBM i 830 Repair Manual page 309

Table of Contents

Advertisement

c. Select the Refresh function.
d. Move to the "Display HSL Information" screen for the first failing resource.
53. For the first failing resource, did the failing port number change?
No
Yes
Exchange the HSL I/O Bridge in the frame of the first failing resource
(see "SIIOADP" on page 585). Then go to step 79 on page 298 of this
procedure.
54. Is the HSL cable an optical HSL cable?
Yes
No
Go to step 56 of this procedure.
55. Examine the state of the LEDs associated with the optical ports where the
HSL cable connections are by performing the following: Determine which
LEDs to examine using the table below.
Table 13. LED Locations
Frame type
FC 5074, 5078/0578
Models 830/SB2
Models 840/SB3
Examine both LEDs at the ports for each end of the optical cable. Are all four
(4) LEDs lighted?
No
Yes
Go to step 58 of this procedure.
56. Exchange the HSL cable (see "SIRGCBL" on page 588).
57. Is the leading port status of the HSL link from the first failing resource
"failed"?
Yes
No
The link is now functioning. Go to step 79 on page 298 of this
procedure.
58. Exchange these FRUs in the following order:
Chapter 3. Problem Isolation Procedures (PIPs), Failing Items, and Symbolic FRU Isolation
Bus, High-Speed Link (HSL) PIPs
LED locations
LEDs are located on the HSL I/O Bridge
card directly below the optical ports for the
HSL cable. There is one (1) LED associated
with each port and they are labeled as x-1L,
x-2L, y-1L, y-2L, where x and y are the port
numbers.
LEDs are located in pairs directly below the
optical ports for the HSL cable. There is one
(1) LED associated with each port and they
are labeled as B0-1L, B0-2L, B1-1L, B1-2L.
See Figure 33 on page 717.
LEDs are located in pairs either above or
below the optical ports. The two (2) LEDs
closest to (above or below) the optical port
pair for the cable belong to that port pair.
There is one (1) LED associated with each
port and they are labeled as x-1L, x-2L, y-1L,
y-2L, where x equal D0 or E0 and y equals
D1 or E1.
See Figure 40 on page 733.
295

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

I sb3I 840I sb2

Table of Contents