IBM i 830 Repair Manual page 370

LIC PIPs
0006: There are new devices attached to the system that do not have Licensed
Internal Code installed.
Ask your next level of support for assistance.
This ends the procedure.
0007: Some of the configured disk units have device parity protection disabled
when the system expected device parity protection to be enabled.
Are the disk units part of a 9337 subsystem?
No
↓
Select DST using Function 21 (see "Control Panel Functions" in the iSeries Service
Functions information).
Correct the problem by doing the following:
1. Select the Work with disk units option.
2. Select the Work with disk unit recovery option.
3. Select the Correct device parity protection option.
4. Follow the on-line instructions.
This ends the procedure.
0008: A disk unit has no more alternate sectors to assign.
1. Determine the failing unit by type, model, serial number or address given in
2. See the service information for the specific storage device. Use the disk unit
This ends the procedure.
0009: The procedure to restore a disk unit from the tape unit did not complete.
Continue with the disk unit exchange recovery procedure (see "Disk Service
Support" in "Recovery Procedures" on page 893).
This ends the procedure.
000A: There is a problem with a disk unit subsystem. As a result, there are
missing disk units in the system.
Perform the following:
1. Select DST using Function 21 (see "Control Panel Functions" in the iSeries
2. On the Service Tools display, select the Start a Service Tool option (see the iSeries
3. Select the Product activity log option on the Start a Service Tool display.
356
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1
Yes
If the protection was stopped without using the Stop device parity protection
option of DST, use the 9337 device documentation and follow the manual
process to enable device parity protection.
words 4-7 (see "Hardware SRC Formats" in the iSeries Service Functions ).
reference code listed below for service information entry.
432x 102E, 660x 102E, 671x 102E (see Chapter 2. Unit Reference Codes)
9337 7xx0, 8xx0, Dxx0, Exx0 (x can be a number from 0 through 8)
Service Functions information).
Service Functions).