Front Impact Sensor Replacement - Honda Civic 2002-2003 Service Manual

Front Impact Sensor Replacement
Removal
1. Disconnectthe battery negative cable, and wait at
least 3 minutes before beginning work.
2. Disconnectthe driver's airbag 4P connector (see
step 2 on page 23-211. the front passenger's airbag
4P connector (see step 3 on page 23-21), both seat
belt tensioner 2P connectors (see step 5 on page
23-22), and both seat belt buckle 4P connectors (see
step 6 on page 23-22).
3. Remove the front inner fender (see page 20-102).
4. Disconnect the engine compartment wire harness
2P connector (A), and remove the two Torx bolts (B)
using a Torx T30 bit, then remove the front impact
sensor (C).
~
'---'''''1 --
p;;",'-:J
I
Installation
1. Install the new front impact sensor with new Torx
bolts (AI, then connect the engine compartment wire
harness 2P connector (8) to the front impact sensor
(C).
2. Reconnect the battery negative cable.
3. After installing the front impact sensor, confirm
proper system operation: Turn the ignition switch
ON (II); the SRS indicator should come on for about
6 seconds and then go off.
23-125