4
Performing Initial Configuration of the SCOPIA Elite
MCU
When you finished installing the MCU, you need to perform the initial configuration during which
you configure the basic features. After the initial configuration the MCU should be ready for use.
Setting the IP Address for Both Blades
You use the serial port on the SCOPIA Elite 5200 Series MCU front panel to assign a new IP address
to your MCU. You must assign the IP address before you connect the MCU to the network.
Before You Begin
Make sure you have these items:
RADVISION | Installation Guide for SCOPIA Elite 5200 Series MCU Version 7.5
•
•
•
•
•
•
•
•
•
Dedicated IP addresses for the two Media Blades
•
Dedicated subnet mask for the MCU
•
IP address of the default router the MCU uses to communicate over the network
•
PC with available serial port and terminal emulator software installed
•
Serial cable
Performing Initial Configuration of the SCOPIA Elite MCU | 17