Configuring Network Settings - RADVision Scopia XT5000 Series User Manual

3. Use the arrow keys on the XT Remote Control Unit to position the image, and then press
4. Press 2 to align the bottom right corner.
5. Use the arrow keys on the XT Remote Control Unit to position the image, and then press
6. To configure network settings, select Next and continue with

Configuring Network Settings

About this task
This procedure describes how to set up the network settings and the IP address the system uses for
placing a call.
If you are modifying the network settings after initial setup, navigate to Configure > Network > GLAN 1
from the Main menu. For more information, see Installation Guide for Scopia XT Series.
Before you begin
This procedure is performed as part of the Quick Setup Wizard, after
page 25. Consult with your network administrator to configure these fields.
Access the quick setup wizard from the endpoint or web interface, as described in
Setup Procedure
Procedure
1. Press ok/menu and select one of the following from the IP Address Mode list:
User Guide for Scopia XT5000 Series Version 3.2
ok/menu.
ok/menu.
on page 27.
on page 22.
• Automatic: (Default) Select this option if the system gets its IP address automatically
(using DCHP).
The IP address, Subnet mask, Gateway, and DNS fields appear as read-only. See
Table 2: Configuring IP addresses
• Manual: Select this option if you require a static IP address. This is required, for
example, if the XT Series is connected directly to the Internet, without any address
translation, or when other external endpoints need to dial to this endpoint as an MCU.
Enter the fields as described in
To secure SIP connections using TLS certificates, your system must have a static IP
address, since the system generates the certificate request using its IP address as the
Common Name (CN). For more information, see Administrator Guide for Scopia XT
Series.
Configuring Network Settings
Adjusting the Image Position
on page 28 for a description of these fields.
Table 2: Configuring IP addresses
on
Accessing the Quick
on page 28.
Getting Started | 27