Macro Keys; Registering Or Editing A Macro - Oce fx2081 User Manual

Macro keys

If you perform the same operaton repeatedly, you can automate the operaton
usng a macro. A macro s a seres of steps grouped together as a sngle command to
accomplsh the operaton automatcally.
A macro key can record up to 60 steps.
NOTE
• Press <Reset> first when you use other functons wthn a few mnutes after
executng Macro.
• When the followng functons are set to ON, you cannot regster or run the macro
program.
– "Network authentcaton settngs" (page 9-49)
– "User Access/Cost Accountng" (page 8-8)
– "User Logn Settng" (page 9-27)
– "Copy Protecton" (page 9-92)
• "Scan to user", "Scan to bulletn board", and operatons usng the personal
address book (page 3-2 and 9-95) cannot be regstered n Macro.
• You can assgn [Macro Program] to a soft key. (See "Soft keys" on page 9-77.)

Registering or editing a Macro

1
In the standby mode except the "Prnter mode", "Scan to Prnter", "Scan to
user", and "Scan to bulletn board", press [Others], [Macro Program].
NOTE
When steps have already been regstered n Macros, the correspondng lst of steps
for that key wll be dsplayed. In that case, press [Enter].
2
Press [Enter/Edt].
3
Select the macro key you want to regster.
9-82 M
acro kEyS