Specifying the initial settings
If you press <Reset> durng the ntal setup, your machne wll return to the
standby mode. You can save the settngs you have made by selectng [Enter] as
shown below.
1
Press <Settng> on the control panel.
2
Press [User Install].
3
The user nstall lst s dsplayed.
4
Set the desred tem. (See page 1-25 to 1-30)
5
After settng all the tems, press <Reset> to return to the standby mode.
Prnt out the "Fax Settngs Lst" to nsure that your settngs are correct. (See
page 10-2.)
1-24
u
i
SEr
nStall