Deleting Program Data; Deleting Macro Data; Formatting Hard Disk; Partition List Print Out - Oce OP30C Operation Manual

2. Printer Settings
Item No.

Deleting font data

53
Deletes the selected font data from the Hard
disk.

Deleting program data

54
Deletes the selected program data from the
Hard disk.

Deleting macro data

55
Deletes the selected macro data from the
Hard disk.

Formatting Hard Disk

56
If "OK" is selected here, the machine will
start formatting the Hard Disk.

Partition List print out

57

RAM disk ON/OFF

58

RAM disk size

59
Sets the amount of memory that will be used
as a RAM disk. The maximum size that can
be selected is the total amount of memory
installed minus the amount used by the
system (48 MB).

Reading data

60
Reads the selected data on the RAM disk.

Reading program data

61
Reads the selected program data on the
RAM disk.

Writing data

62
If "OK" is selected here, the machine will
enter a "waiting for data" state until data is
sent from the host computer. To exit this
state, select the "GO" command in the
printer mode and then press the Enter key.
Item Display message Available settings
Delete Font Select the name of
the font from among
those displayed.
Delete Program Select the name of
the partition which
holds the program
from among those
displayed.
Delete Macro Select the name of
the partition which
holds the macro
from among those
displayed.
Format No, OK
List of Partitions No, Print
RAM DISK Mode On, Off
RAM DISK Size 01 - 1024 (MBytes)
Read Data Select the name of
the partition which
holds the data from
among those
displayed.
Read Program Select the name of
the partition which
holds the program
from among those
displayed.
Write Data OK
2-13
Remarks
Displayed only when there is
appropriate font data on the Hard
Disk.
Displayed only when there is
appropriate program data on the
Hard Disk.
Displayed only when there is
appropriate macro data on the
Hard Disk.
Displayed only when formatting of
the Hard Disk is required.
Only when the optional Hard Disk
is installed.
Displayed only when "On" is
selected under the "RAM disk ON/
OFF" setting (item No.: 58).
Displayed only when there is
appropriate data in the RAM disk.
Displayed only when there is
appropriate program data in the
RAM disk.
Displayed only when "On" is
selected under the "RAM disk ON/
OFF" setting (item No.: 58).