Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1406

ENGINE OVERHAUL -
Guide A: 17.9 mm
Push rod
Guide B
Guide A: 18.9 mm
Guide C
Guide A: 20.9 mm
Base
Guide A: 21.9 mm
Push rod
Front mark
Front
mark
Guide C
REMOVAL SERVICE POINTS
AA" CONNECTING ROD CAP REMOVAL
Note the cylinder No. on the side of the connecting rod's
Cylinder No. large end for identification during reassembly.
AB" PISTON PIN REMOVAL
The special tool's piston pin setting tool (MD998780) is
configured of the parts shown in the left illustration.
1. Insert the special tool's push rod in from the front mark
2. Set the piston and connecting rod assembly onto the
3. Push out the piston pin using a press.
Base
Piston and Connecting Rod
(arrow) side of the piston's front face, and install guide
C.
special tool's piston pin setting base so that the front
mark faces upward.
NOTE
After removing the piston pin, group the piston, piston
pin and connecting rod for each cylinder No.
11B-57