Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1399

11B-50
MD998705
Guide pin
Part for tapping in
the rear bearing
Guide pin
Front bearing
Ratchet ball
ENGINE OVERHAUL -
3. Align and insert the special tool into the guide pin, and
MD998705
"CA COUNTER BALANCE SHAFT FRONT BEARING
1. Remove the part for tapping in the rear bearing from
2. Install the guide pin onto the cylinder block.
3. Align the ratchet ball of the special tool with the oil hole,
Oil hole
MD998705
Oil Pump and Oil Pan
tap in the counter balance shaft rear bearing right.
INSTALLATION
the special tool.
and set the counter balance shaft front bearing.