Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1398

MB991603
MD998372
MB991603
MB991603
MD998705
Rear bearing
left
Guide pin
Rear bearing right
Ratchet ball
ENGINE OVERHAUL -
AE" COUNTER BALANCE SHAFT REAR BEARING
1. Pull out the counter balance shaft rear bearing right from
2. When removing the counter balance shaft rear bearing
INSTALLATION SERVICE POINTS
"AA COUNTER BALANCE SHAFT REAR BEARING
1. Install the special tool (MB991603) onto the cylinder block.
2. Set the counter balance shaft rear bearing left into the
MD998705
3. Tap in the counter balance shaft rear bearing left.
"BA COUNTER BALANCE SHAFT REAR BEARING
1. Install the guide pin onto the cylinder block.
2. Align the ratchet ball of the special tool with the oil hole,
Oil hole
MD998705
Oil Pump and Oil Pan
REMOVAL
the cylinder block using the special tool (MD998372).
left, install the special tool (MB991603) onto the front
of the cylinder block, and then remove the bearing using
the special tool (MD998372).
LEFT INSTALLATION
special tool (MD998705).
NOTE
There is no oil hole on the counter balance shaft rear
bearing left.
RIGHT INSTALLATION
and set the counter balance shaft rear bearing right.
11B-49