Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1401

11B-52
Counter balance
shaft left
MD998285
MD998285
Phillips driver
ENGINE OVERHAUL -
"GA OIL PUMP DRIVE GEAR/OIL PUMP DRIVEN
Apply sufficient engine oil onto the gears, align the match
Match marks
marks, and assemble.
"HA OIL PUMP CASE INSTALLATION
1. Install the special tool onto the front end of the crankshaft,
Counter balance
shaft right
2. Install the oil pump case through the new oil pump case
3. Install the oil filter bracket through the oil filter bracket
4. Tighten the oil pump case at the specified torque 23
"IA FLANGE BOLT INSTALLATION
1. Insert a Phillips driver (shaft diameter 8 mm) by 60 mm
2. Tighten the flange bolt at the specified torque 36 ± 3
Oil Pump and Oil Pan
GEAR INSTALLATION
and apply a light coat of engine oil onto the periphery
of the guide. If an oil seal is installed on the oil pump
case, always use a guide.
gasket, and temporarily tighten the bolts other than the
oil filter bracket tightening bolt.
gasket, and temporarily tighten with the bolt.
± 3 N•m, and the oil filter bracket at the specified torque
19 ± 3 N•m.
or more into the hole on the left side of the cylinder block
to stop the rotation of the counter balance shaft left.
N•m.