Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1427

00-8
GENERAL -
MB991529
Indication of diagnosis code by warning lamp
When the diagnosis code No.24 is output
1.5 secs.
On
Off
Pause Tens
time 3 signal
secs.
METHOD OF ERASING DIAGNOSIS CODES
WHEN USING THE MUT-II
Connect the MUT-II to the diagnosis connector and erase the diagnosis code.
Caution
Turn the ignition switch to "LOCK"(OFF) position before connecting or disconnecting the MUT-II.
WHEN NOT USING THE MUT-II
1. Turn the ignition switch to "LOCK"(OFF) position.
2. After disconnecting the battery cable from the battery ( - ) terminal for 10 seconds or more, reconnect
the cable.
3. After the engine has warmed up, run it at idle for about 15 minutes.
How to Use Troubleshooting/Inspection Service Points
WHEN USING THE WARNING LAMP
1. Use the special tool to earth No.1 terminal (diagnosis
2. Turn the ignition switch to "ON" position.
3. Read out a diagnosis code by observing how the warning
Applicable systems
System name
ACD, AYC
ABS
0.5 sec.
0.5 sec.
Place Units
division signal
2 secs.
control terminal) of the diagnosis connector.
lamp flashes.
When no diagnosis code is output*
On
Off
Warning lamp name
ACD mode indicator lamp
ABS warning lamp
0.25 sec.