Replacement 29 Mpf Feed Solenoid (Pl3.1.98) - Dell 3130cn Service Manual

Replacement 29 MPF FEED SOLENOID (PL3.1.98)

1) Replace the MPF FEED SOLENOID to the printer by mating the two holes on the MPF FEED
SOLENOID with the bosses on the printer.
Ensure that 8mm screws are used to secure the MPF FEED SOLENOID. Use of 10mm
screws will damage the frame.
2) Secure the MPF FEED SOLENOID to the printer using the one screw (silver, tap, 8mm).
3) Route the harness of the MPF FEED SOLENOID to the DUCT ASSY DRV PH.
The harness color of the MPF FEED SOLENOID (gray) does not match that of the printer
(yellow).
4) Engage the connector (P/J234) of the MPF FEED SOLENOID.
Continues to the next page.
Version 3 2008.05.30
Chapter 3 Removal and Replacement Procedures (RRPs)
3)
2)
1)
10mm 8mm
3 - 155
4)-2
4)-1
Zna03076KB