Replacement 19 SHIELD ASSY ESS (PL9.1.45)
When performing the step described below, ensure that the harness will not be caught
between the printer and the SHIELD ASSY ESS.
1)
Route the four connectors to between the ELECTRONIC SUB-SYSTEM CONTROL BOARD
and the SHIELD ESS, and then attach the SHIELD ASSY ESS to the printer.
2)
Secure the SHIELD ASSY ESS to the printer using the fourteen screws (silver, 6mm).
Continues to the next page.
Version 3 2008.05.30
Chapter 3 Removal and Replacement Procedures (RRPs)
1)-2
3 - 135
1)-1
2)
2)
2)
2)
2)
2)
2)
2)
2)
2)
2)
2)
2)
2)
Zna03319KB