Fip1.9 007-340-00 Restart Printer - Dell 3130cn Service Manual

FIP1.9 007-340-00 Restart Printer

Step
Possible causative parts:
PWBA MCU (PL9.1.20)
HARN ASSY R SIDE (PL10.1.15)
DRIVE ASSY MAIN (PL8.1.2)
Checking the detail error code.
A detailed error code is displayed by pushing
1
and key simultaneously.
Is "Code:00" displayed on the LCD?
Checking the Transfer Assy, Fuser and Black Print Car-
tridge for installation
2
Are the Transfer Assy, Fuser and Black Print Cartridge
installed correctly?
3 Does the error still occur when the power is turned ON?
Checking the connectors for connection
Check the connections between the PWBA MCU and
4
DRIVE ASSY MAIN.
Are P/J22 and P/J222 connected surely?
5 Does the error still occur when the power is turned ON?
Checking the Main Motor in the DRIVE ASSY MAIN for
rotation
Does the Main Motor function normally?
6
Checked by [Digital Output] - [DO-0(Control Panel)/MAIN
MOTOR(PC)] in diagnosis. During the test, close the Front
Cover.
Checking the DRIVE ASSY MAIN for installation
7
Is the DRIVE ASSY MAIN installed correctly?
8 Does the error still occur when the power is turned ON?
Checking the connectors of the Main Motor on the DRIVE
ASSY MAIN for connection
9 Check the connections between the PWBA MCU and
DRIVE ASSY MAIN.
Are P/J22 and P/J222 connected surely?
Checking the HARN ASSY R SIDE for continuity
Disconnect P/J22 from the PWBA MCU.
10
Disconnect P/J222 from the DRIVE ASSY MAIN.
Is each cable of P/J22 <=> P/J222 continuous?
Version 3 2008.05.30
Check
key,
1 - 185
Chapter 1 Troubleshooting
Yes
key
Go to step 2.
Go to step 4.
Go to step 4.
Go to step 6.
Go to step 6.
Replace the
PWBA MCU.
(Refer to Removal
30/Replacement
14)
Go to step 8.
Go to step 9.
Go to step 10.
Go to step 11.
No
"01":Go to
FIP1.10.
"03":Go to
FIP1.12.
"04":Go to
FIP1.13.
Reseat the Trans-
fer Assy, Fuser
and/or Black Print
Cartridge, then go
to step 3.
End of work
Reconnect the
connector(s)
P/J22 and/or
P/J222 surely,
then go to step 5.
End of work
Go to step 7.
Reseat the
DRIVE ASSY
MAIN, then go to
step 8.
End of work
Reconnect the
connector(s) P/
J22 and/or P/J222
surely.
Replace the
HARN ASSY R
SIDE.