Removal 11 Right Cover (Pl1.1.6) - Dell 3130cn Service Manual

Removal 11 RIGHT COVER (PL1.1.6)

Steps 1 through 3 are for reference. Before removing this component, check that Steps 1 through 3
have been performed.
1) Open the FRONT COVER (PL1.2.1).
2) Remove the FUSER. (Removal 8)
3) Remove the REAR COVER. (Removal 10)
4) Remove three screws (silver, tap, 10mm) that fix the RIGHT COVER (PL1.1.6) to the printer.
5) Release the two holes on the RIGHT COVER from the bosses on the printer.
6) Release the one backside hook and two frontside hooks on the RIGHT COVER, and then
remove the RIGHT COVER diagonally backward.
Go to the next removal step:
Removal 12 LEVER FUSER D (PL6.1.18), Removal 13 OPERATOR PANEL (PL1.2.97),
Removal 14 FRONT COVER (PL1.2.98), Removal 15 MPF FEED SOLENOID (PL3.1.98),
Removal 16 ROLL ASSY MSI (PL3.1.8), Removal 17 FEED DRIVE ASSEMBLY (PL8.1.7),
Removal 18 SIZE SWITCH ASSEMBLY (PL7.1.18), Removal 19 BREAKER GFI INLET
(PL9.1.43)
Version 3 2008.05.30
Chapter 3 Removal and Replacement Procedures (RRPs)
6)-1
4)
5)
6)-1
6)-1
4)
3 - 18
4)
5)
6)-2
Zna03016KB