Replacement 4 Integrated Feeder Assembly (Pl3.2.99) - Dell 3130cn Service Manual

Replacement 4
4)
When performing the step described below, take care not to drop and lose the SPRING
EARTH on the right side of the INTEGRATED FEEDER ASSEMBLY.
When performing the step described below, check that the SPRING EARTH on the right
side of the INTEGRATED FEEDER ASSEMBLY is in contact with the PLATE EARTH of
the printer.
1) Insert the INTEGRATED FEEDER ASSEMBLY diagonally into the printer so that the right
side of the INTEGRATED FEEDER ASSEMBLY goes in first.
2) Route the harness with the two connectors coming from the INTEGRATED FEEDER ASSEM-
BLY and the connector of the CLUTCH ASSY PH TURN out of the hole on the printer from
inside.
3) Insert the bearing, the clutch and the two bosses (One is provided with the SPRING EARTH.)
on the right side of the INTEGRATED FEEDER ASSEMBLY to the holes on the printer.
4) Insert the left side boss of the INTEGRATED FEEDER ASSEMBLY into the hole on the
printer.
5) Secure the INTEGRATED FEEDER ASSEMBLY to the printer using the two screws (silver,
tap, 10mm).
Continues to the next page.
Version 1 2008.01.08
INTEGRATED FEEDER ASSEMBLY (PL3.2.99)
5)
5)
Chapter 3 Removal and Replacement Procedures (RRPs)
1)
3)
3)
NOTE
3 - 100
NOTE
2)
Zna03081KA