Removal 7 Duplex Gate (Pl6.1.13) - Dell 3130cn Service Manual

Removal 7 DUPLEX GATE (PL6.1.13)
The FUSER part is very hot. Take added care not to get burned when performing the ser-
vice operation.
1) Open the FRONT COVER (PL1.2.1).
2)-1
2)-2
2) Open the DUPLEX GATE (PL6.1.13) to about 45 degrees so that the flat faces of the left side
pivot of the DUPLEX GATE comes parallel with the U-shaped notch. Pull out the left side
pivot of the DUPLEX GATE from the U-shaped notch diagonally backward.
3) Pull out the right side pivot of the DUPLEX GATE from the hole on the printer.
Version 3 2008.05.30
Chapter 3 Removal and Replacement Procedures (RRPs)
3)
3 - 14
Zna03010KB