Removal 22 Arm Assembly (Pl7.1.98) - Dell 3130cn Service Manual

Removal 22 ARM ASSEMBLY (PL7.1.98)

Steps 1 through 5 are for reference. Before removing this component, check that Steps 1 through 5
have been performed.
1) Open the FRONT COVER (PL1.2.1).
2) Remove the FUSER. (Removal 8)
3) Remove the REAR COVER. (Removal 10)
4) Remove the RIGHT COVER. (Removal 11)
5) Remove the LEFT COVER. (Removal 20)
6) Release the hook of the SHAFT PIVOT (PL1.2.8) that fixes the LINK R (PL7.1.13) to the
FRONT COVER (PL1.2.1), an then pull the SHAFT PIVOT to the outside and remove the
LINK R from the FRONT COVER.
7) Remove the two screws (silver, tap, 10mm) that fix the SUPPORT LINK R (PL7.1.12) to the
printer.
8) Remove the SUPPORT LINK R from the printer.
Continues to the next page.
Version 3 2008.05.30
Chapter 3 Removal and Replacement Procedures (RRPs)
6)-3
6)-2
6)-1
3 - 38
7)
8)
7)
Zna03204KB