Fip1.43 Load Tray N Or Mpf 024-910/024-911/024-914 - Dell 3130cn Service Manual

FIP1.43 Load Tray N or MPF 024-910/024-911/024-914

Step
Possible causative parts:
CASSETTE ASSY 250 (PL2.1.1)
CASSETTE ASSY 550 OPT (PL12.4.1)
SWITCH ASSY SIZE (PL7.1.18)
SWITCH ASSY SIZE OPT (PL12.2.5)
HARN ASSY REGI SNR (PL3.2.37)
HARN ASSY R SIDE (PL10.1.15)
SENSOR PHOTO (REGI SENSOR) (PL3.2.30)
PWBA MCU (PL9.1.20)
Checking the paper size
1
Does the paper size in use meet the specification?
Checking the paper for size setup
2 Does the paper size in use match the size set through the
control panel?
3 Does the error still occur when printing?
Checking after reseating the Paper Cassette Guide
4 Reseat the end guide of the Paper Cassette.
Does the error still occur when printing?
Checking after replacing the CASSETTE ASSY 250 or 550
5 Replace the CASSETTE ASSY 250 or 550.
Does the error still occur when printing?
Checking the SENSOR PHOTO (REGI SENSOR) for oper-
ation
Does the number on the screen increase by one, every
6 time the actuator of the SENSOR PHOTO (REGI SEN-
SOR) is operated?
Checked by [Digital Input] - [DI-3(Control Panel)/REGI
SNR(PC)] in diagnosis.
Checking the SWITCH ASSY SIZE of Tray 1 for operation
Does the SWITCH ASSY SIZE operate properly?
7
Checked by [Digital Input] - [DI-18(Control Panel)/
CASSETTE1 SIZE(PC)] in diagnosis.
Checking the SWITCH ASSY SIZE of Tray 2 for operation
Does the SWITCH ASSY SIZE OPT operate properly?
8
Checked by [Digital Input] - [DI-20(Control Panel)/
CASSETTE2 SIZE(PC)] in diagnosis.
Version 1 2008.02.15
Check
1 - 239
Chapter 1 Troubleshooting
Yes
Go to step 2.
For Tray1 and
Set the paper size
Tray2:
through the con-
Go to step 4.
trol panel, then go
For MPF:
Go to step 6.
For Tray1 and
Tray2:
Go to step 4.
For MPF:
Go to step 6.
Go to step 5.
Go to step 7.
Replace the
PWBA MCU.
(Refer to Removal
30/Replacement
14).
SWITCH ASSY
Go to step 8. SIZE. (Refer to
Replacement 26)
SWITCH ASSY
Go to step 9. SIZE OPT. (Refer
to Removal 44/
Replacement 46)
No
Use the paper
that meets the
specification.
to step 3.
End of work
End of work
End of work
Go to step 10.
Replace the
Removal 18/
Replace the