Fip1.46 Error Y Cart 093-919 - Dell 3130cn Service Manual

FIP1.46 Error Y Cart 093-919

Step
Possible causative parts:
CARTRIDGE ASSY (Y) (PL5.1.21)
DISPENSER ASSY (PL5.1.12)
HARN ASSY LV TOP (PL10.1.16)
PWBA MCU (PL9.1.20)
Checking the Toner Tape for staying
1
Has the Toner Tape been pulled out?
2 Does the error still occur when the power is turned ON?
Checking after replacing the CARTRIDGE ASSY (Y)
3 Replace the CARTRIDGE ASSY (Y).
Does the error still occur when the power is turned ON?
Checking the Dispenser Motor for rotation
Does the Dispense Motor function normally?
4 Checked by [Digital Output] - [DO-21(Control Panel)/
TONER MOTOR Y ON(PC)] in diagnosis. During the test,
close the interlock switch (HARN ASSY INTERLOCK).
Checking the connector for connection
Check the connectors between the PWBA MCU and DIS-
5
PENSER ASSY.
Are P/J18 and P/J181 connected surely?
6 Does the error still occur when the power is turned ON?
Checking the HARN ASSY LV TOP for continuity
Disconnect P/J18 from the PWBA MCU.
7
Disconnect P/J181 from the DISPENSER ASSY.
Is each cable of P/J18 <=> P/J181 continuous?
Checking the power to DISPENSER ASSY
Disconnect P/J18 on the PWBA MCU.
8 Are the voltages across ground <= >J18-A1pin/A2pin on
PWBA MCU, about +24 VDC when the interlock switch
(HARN ASSY INTERLOCK) is pushed.
Version 1 2008.02.15
Check
1 - 246
Chapter 1 Troubleshooting
Yes
Go to step 2. Tape out, then go
Go to step 3.
Go to step 4.
Check the gear of
the Auger is not
damaged. If the
gear is damaged,
replace the DIS-
PENSER ASSY
(Y). (Refer to
Removal 24/
Replacement 20)
Replace the
PWBA MCU.
(Refer to Removal
30/Replacement
14)
Go to step 6.
then go to step 6.
Go to step 7.
Go to step 8. HARN ASSY LV
Replace the DIS-
PENSER ASSY.
(Refer to Removal (Refer to Removal
24/Replacement 30/Replacement
20)
No
Pull the Toner
to step 2.
End of work
End of work
Go to step 5.
Reconnect the
connector(s)
P/J18 and/or
P/J181 surly,
End of work
Replace the
TOP.
Replace the
PWBA MCU.
14)