Removal 31 TOP COVER (PL1.1.1)
Steps 1 through 5 are for reference. Before removing this component, check that Steps 1 through 5
have been performed.
1)
Open the FRONT COVER (PL1.2.1).
2)
Remove the FUSER. (Removal 8)
3)
Remove the REAR COVER. (Removal 10)
4)
Remove the RIGHT COVER. (Removal 11)
5)
Remove the LEFT COVER. (Removal 20)
6)
Remove the five screws (silver, tap, 10mm) that fix the TOP COVER (PL1.1.1) to the printer.
7)
Disengage the two holes of the TOP COVER from the left and right bosses of the printer.
8)
Lift up the TOP COVER to disengage the front and left bosses of the TOP COVER from the
holes of the printer. Remove it.
Go to the next removal step:
Removal 32 FAN (PL9.1.10) or Removal 37 INTERLOCK SWITCH (PL9.1.3)
Version 3 2008.05.30
6)
6)
8)-1
Chapter 3 Removal and Replacement Procedures (RRPs)
6)
6)
7)
8)-2
3 - 56
7)
6)
Zna03043KB