Removal 28 Drive Assy K (Pl8.1.10) - Dell 3130cn Service Manual

Removal 28 DRIVE ASSY K (PL8.1.10)

Steps 1 through 7 are for reference. Before removing this component, check that Steps 1 through 7
have been performed.
1) Open the FRONT COVER (PL1.2.1).
2) Remove the FUSER. (Removal 8)
3) Remove the REAR COVER. (Removal 10)
4) Remove the RIGHT COVER. (Removal 11)
5) Remove the LEFT COVER. (Removal 20)
6) Remove the SHIELD ASSY ESS. (Removal 25)
7) Remove the SHIELD MCU. (Removal 27)
9)-1
9)-1
9)-1
8) Disengage the connector (P/J20) on the MACHINE CONTROL UNIT (PL9.1.20).
9) Release the harness of the K Mode Sensor from the six clamps, and then put the harness into
the hole of the frame to remove it.
Continues to the next page.
Version 3 2008.05.30
Chapter 3 Removal and Replacement Procedures (RRPs)
9)-2
3 - 50
8)
9)-1
9)-1
9)-1
Zna03212KB