Removal 24 Toner Dispenser Motor (Pl5.1.12) - Dell 3130cn Service Manual

Removal 24 TONER DISPENSER MOTOR (PL5.1.12)

Described below is the removal procedure common among the TONER DISPENSER
MOTORs (C), (M), (Y), and (K).
Steps 1 through 4 are for reference. Before removing this component, check that Steps 1 through 4
have been performed.
1) Open the FRONT COVER (PL1.2.1).
2) Remove the FUSER. (Removal 8)
3) Remove the REAR COVER. (Removal 10)
4) Remove the LEFT COVER. (Removal 20)
When performing the step below, leave the junction connector on the printer side
cable.
5) Release the four sets of connectors and harness of the TONER DISPENSER MOTOR
(PL5.1.12) from the DUCT HARNESS MOT (PL5.1.16), and disengage the four sets of connec-
tors of the TONER DISPENSER MOTOR.
6) Release two hooks that fix the DUCT HARNESS MOT to the printer.
7) Release the lug on the DUCT HARNESS MOT from the printer by moving the DUCT HAR-
NESS MOT slightly upward. Pass the four sets connectors of the TONER DISPENSER
MOTOR through the hole on the DUCT HARNESS MOT, and then remove the DUCT HAR-
NESS MOT.
Continues to the next page.
Version 3 2008.05.30
Chapter 3 Removal and Replacement Procedures (RRPs)
6)
5)
6)
5)
3 - 44
5)
5)
7)
Zna03038KA