Fip1.21 010-317 Restart Printer - Dell 3130cn Service Manual

FIP1.21 010-317 Restart Printer

Step
Possible causative parts:
FUSER ASSY (PL6.1.10)
PWBA MCU (PL9.1.20)
HARN ASSY FUSER (PL6.1.11)
HARN ASSY LV TOP (PL10.1.16)
Checking the FUSER ASSY for installation
1
Is the FUSER ASSY installed correctly?
2 Does the error still occur when the power is turned ON?
Checking the connectors for connection
Remove the FUSER ASSY.
Check the connections between the PWBA MCU and
3 FUSER ASSY.
Warning: Start the operation after the FUSER ASSY
has cooled down.
Are P/J17, P/J171 connected surely?
Checking the HARN ASSY FUSER for continuity
Remove the FUSER ASSY.
Warning: Start the operation after the FUSER ASSY
4 has cooled down.
Disconnect P/J17 from the PWBA MCU.
Disconnect P/J171 from the FUSER ASSY.
Is each cable of P/J17 <=> P/J171 continuous?
Checking after replacing the FUSER ASSY
Replace the FUSER ASSY. (Refer to Removal 8/ Replace-
ment 36.)
5
Warning: Start the operation after the FUSER ASSY
has cooled down.
Does the error still occur when the power is turned ON?
*1: Though some kind of foreign noise would be possible cause, go to FIP1.73 Electrical Noise in Other
FIP and check, to make sure.
Version 1 2008.02.15
Check
1 - 201
Chapter 1 Troubleshooting
Yes
Go to step 2. FUSER ASSY,
then go to step2.
Go to step 3. End of work *1
Go to step 4.
then go to step 4.
Go to step 5.
Replace the
PWBA MCU.
(Refer to Removal
30/ Replacement
14.)
No
Reseat the
Reconnect the
connector(s)
P/J17 and/or
P/J171 surely,
Replace the
HARN ASSY
FUSER.
End of work