Dell 3130cn Service Manual page 578

Replacement 4
When replacing the CLUTCH, match the harness color of the CLUTCH with that of the fit-
ting groove of the CLUTCH.
The harness color of the CLUTCH ASSY PH REGI is gray.
The harness color of the CLUTCH ASSY PH FEED is yellow.
The harness color of the CLUTCH ASSY PH TURN is blue.
6) Replace the CLUTCH ASSY PH FEED to the INTEGRATED FEEDER ASSEMBLY by mat-
ing the fitting groove the CLUTCH ASSY PH FEED with the lug on the INTEGRATED
FEEDER ASSEMBLY.
7) Replace the CLUTCH ASSY PH REGI to the printer by mating the fitting groove on the
CLUTCH ASSY PH REGI with the lug on the printer.
8) Replace the CLUTCH ASSY PH REGI and CLUTCH ASSY PH FEED to the INTEGRATED
FEEDER ASSEMBLY using the e-rings.
9) Route the harnesses along the printer and bind them with the clamps on the INTEGRATED
FEEDER ASSEMBLY and the printer.
When engaging the connectors of the CLUTCHes, match the color of the CLUTCH har-
ness with that of the harness on the printer side.
10) Engage the connector (P/J231) of the CLUTCH ASSY PH REGI, the connector (P/J233) of the
CLUTCH ASSY PH FEED, and the connector (P/J232) of the CLUTCH ASSY PH TURN.
11) Engage the connectors (P/J292 and P/J301) of the INTEGRATED FEEDER ASSEMBLY.
12) Attach the CLAMP to the frame of the printer, secure the harness using the CLAMP.
Continues to the next page.
Version 3 2008.05.30
INTEGRATED FEEDER ASSEMBLY (PL3.2.99)
9)
Chapter 3 Removal and Replacement Procedures (RRPs)
10)
Blue
11)
9)
Gray
7)
6)
8)
8)
3 - 101
12)
10)
10)
Yellow
Zna03082KB