Replacement 12 Fan (Pl9.1.10) - Dell 3130cn Service Manual

Replacement 12 FAN (PL9.1.10)

When performing the step described below, take care to check the orientation of the FAN.
(Attach the FAN so that its labeled surface faces front.)
When performing the step describe below, ensure that the harness of the FAN will not be
caught between the FAN and the SHIELD LVPS.
1) Mate the notch of the FAN with the rib of the printer and attach the FAN to the printer.
2) Secure the FAN to the printer using the two screws (silver, 30mm).
3) Route the harness of the FAN to the hook on the frame.
4) Engage the connector (P/J503) of the FAN to the LOW VOLTAGE POWER SUPPLY.
5) Secure the harness of the FAN with the clamp.
Go to the next replacement step:
Replacement 13 TOP COVER (PL1.1.1)
Version 1 2008.01.08
4)
5)
5)
Chapter 3 Removal and Replacement Procedures (RRPs)
3)
1)
3 - 121
2)
LABEL
[NOTE]
2)
Zna03312KA