Removal 37 Interlock Switch (Pl9.1.3); Removal 38 Photoconductor (Pc) / Developer (Dev) Drive (Pl8.1.2) - Dell 3130cn Service Manual

Removal 37 INTERLOCK SWITCH (PL9.1.3)

Steps 1 through 6 are for reference. Before removing this component, check that Steps 1 through 6
have been performed.
1) Open the FRONT COVER (PL1.2.1).
2) Remove the FUSER. (Removal 8)
3) Remove the REAR COVER. (Removal 10)
4) Remove the RIGHT COVER. (Removal 11)
5) Remove the LEFT COVER. (Removal 20)
6) Remove the TOP COVER. (Removal 31)
11)
10)
7) Disengage the connector (P/J44) of the INTERLOCK SWITCH on the LOW VOLTAGE
POWER SUPPLY (PL9.1.4).
8) Remove the clamp on the SHIELD LVPS (PL9.1.9) that fix the harness of the INTERLOCK
SWITCH.
9) Remove the harness of the INTERLOCK SWITCH from the duct of the printer.
10) Remove the one screw (silver, tap, 16mm) that fixes the INTERLOCK SWITCH to the printer.
11) Remove the INTERLOCK SWITCH.
Go to the next removal step:

Removal 38 PHOTOCONDUCTOR (PC) / DEVELOPER (DEV) DRIVE (PL8.1.2)

Version 3 2008.05.30
Chapter 3 Removal and Replacement Procedures (RRPs)
9)
3 - 70
8)-1
8)-2
8)-1
7)
Zna03050KB