Dell 3130cn Service Manual page 588

6) Replace the LVPS ASSY to the printer by mating the three holes on the SHIELD LVPS with
the bosses on the printer.
Ensure the 8mm screws are used to secure the uppper side of the LVPS ASSY. Use of
10mm screws will damage the frame.
7) Secure the LVPS ASSY to the printer using the six screws (silver, 6mm), the two screws (sil-
ver, tap, 8mm) and the two screws (silver, tap, 10mm).
8) Replace the clamps that fix the harness of the INTERLOCK SWITCH and HARN ASSY AC
IN to the SHIELD LVPS.
9) Engage all the connectors of the LOW VOLTAGE POWER SUPPLY, and then secure the har-
ness with the clamps.
Continues to the next page.
Version 3 2008.05.30
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 111