Removal 33 Harn Assy Ac In (Pl9.1.16) - Dell 3130cn Service Manual

Removal 33 HARN ASSY AC IN (PL9.1.16)

Steps 1 through 6 are for reference. Before removing this component, check that Steps 1 through 6
have been performed.
1) Open the FRONT COVER (PL1.2.1).
2) Remove the FUSER. (Removal 8)
3) Remove the REAR COVER. (Removal 10)
4) Remove the RIGHT COVER. (Removal 11)
5) Remove the LEFT COVER. (Removal 20)
6) Remove the TOP COVER. (Removal 31)
7) Disengage the connector (P/J48) on the LOW VOLTAGE POWER SUPPLY (PL9.1.4).
8) Disengage the connector (P/J482) and FASTON terminal (FS483) on the BREAKER GFI
INLET (PL9.1.43), and then release the grounding wire of the HARN ASSY AC IN (PL9.1.16)
from the clamp.
9) Remove the one screw (silver, with washer, M4, 6mm) that fixes the grounding terminal of the
HARN ASSY AC IN to the printer.
Continues to the next page.
Version 3 2008.05.30
Chapter 3 Removal and Replacement Procedures (RRPs)
7)
9)
8)
8)-1
8)-2
3 - 58
Zna03215KB