Fip1.35 Paper Jam - Dell 3130cn Service Manual

FIP1.35 Paper Jam 075-100

Step
Possible causative parts:
ROLL ASSY FFEED MSI (PL3.1.10)
ROLL ASSY TURN (PL3.2.32)
SENSOR PHOTO (REGI SENSOR) (PL3.2.30)
SOLENOID FEED MSI (PL3.1.3)
CLUTCH ASSY PH TURN (PL3.2.25)
DRIVE ASSY PH (PL8.1.7)
HARN ASSY R SIDE (PL10.1.15)
HARN ASSY REGI SNR (PL3.2.37)
PWBA MCU (PL9.1.20)
Checking the paper condition
1
Is the paper on the MPT wrinkled or damaged?
Checking the paper size setup
2 Does the paper size in use match the size setup set
through the control panel?
3 Does the error still occur when printing?
Checking after reseating the side guides of the MPT
4 Reseat the side guides.
Does the error still occur when printing?
Checking the SENSOR PHOTO (REGI SENSOR) for oper-
ation
Does the number on the screen increase by one, every
5 time the actuator of the SENSOR PHOTO (REGI SEN-
SOR) is operated?
Checked by [Digital Input] - [DI-3(Control Panel)/REGI
SNR(PC)] in diagnosis.
Checking the SOLENOID FEED MSI for operation
Does the SOLENOID FEED MSI operate properly?
6
Checked by [Digital Output] - [DO-2d(Control Panel)/MSI
FEED CLUTCH ON(PC)] in diagnosis.
Checking the CLUTCH ASSY PH TURN for operation
Does the CLUTCH ASSY PH TURN operate properly?
7
Checked by [Digital Output] - [DO-2b(Control Panel)/MSI
TURN CLUTCH ON(PC)] in diagnosis.
Checking the DRIVE ASSY PH for operation
Does the DRIVE ASSY PH operate properly?
8
Checked by [Digital Output] - [DO-a(Control Panel)/PH
MOTOR(FULL)(PC)] in diagnosis.
Version 1 2008.02.15
Check
1 - 219
Chapter 1 Troubleshooting
Yes
Replace the
paper with a new
and dry one, then
go to step 2.
Correct the paper
size through the
Go to step 3.
then go to step 3.
Go to step 4.
Go to step 5.
Go to step 6. Go to step 10.
Go to step 7. Go to step 15.
Go to step 8. Go to step 18.
Go to step 9. Go to step 21.
No
Go to step 2.
control panel,
End of work
End of work